OpenGD77

HB3XPL wrote: ↑

Sun Oct 23, 2022 10:33 am

Hello, there is a problem with this firmware:

On Quick Menu (SK1+Green) is impossible to change values with rotary knob...... like TS Filter value from Off to On

Can you please check !

HB3XPL wrote: ↑

Sun Oct 23, 2022 10:33 am

Hello, there is a problem with this firmware:

On Quick Menu (SK1+Green) is impossible to change values with rotary knob...... like TS Filter value from Off to On

Can you please check !

VK3KYY wrote: ↑

Sat Oct 22, 2022 9:14 pm

A new Alpha version is now available

downloads/MDUV380/Firmware/97f4df95bc11 ... c1f1cbea12

This version fixes the following problems:

* Up / Down arrows now operate squelch and power in the correct direction
* 1750Hz tone can now be sent by holding SK2 during Tx, like on the GD77 etc.
* DTMF characters A,B,C & D can now be entered or sent using Up, SK1+Up, Down , and SK1+Down
* Charcter input cursor position for channel name on the Channel Details screen is now correct
* Channel and VFO scan will start when holding the Up key. i.e no need to hold and wait for the beep before releasing, simply holding down will start the scan

* Slight UI change to VFO Sweep scan.
Rotary control adjusts sweep center frequency.
SK2 + Rotary contorl adjusts step size / over sweep range
Up increases gain
Down decreases gain
SK2 + Up increases lower RSSI threshold
SK2 + Down decreases lower RSSI threshold

* Bug associacted with holding SK2 while changing the Rotary control, while in VFO Scan mode has been fixed.
* In Channel an VFO scan.
The Star ( * ) key is now use to mark a channel or frequency to be skipped duing the current scan
Pressing the Up arrow recommences the scan, if its paused on a busy frequency.