It so happens that my RT82 has a shift of reference frequency (at 144mHz -500Hz, at 70cm already more than 1kHz). When working in analog modes it is not a problem, but when using dmr (especially hotspot) it is already a problem. So far I solve the problem by introducing frequency correction on rt82.
In CPS the calibration tab is inactive.
Reference frequency calibration on RT82
Re: Reference frequency calibration on RT82
CPS calibration tab only reads and writes the data file for the STM32 based radios.R9OBQ wrote: ↑Thu Mar 07, 2024 3:14 amIt so happens that my RT82 has a shift of reference frequency (at 144mHz -500Hz, at 70cm already more than 1kHz). When working in analog modes it is not a problem, but when using dmr (especially hotspot) it is already a problem. So far I solve the problem by introducing frequency correction on rt82.
In CPS the calibration tab is inactive.
It only displays the data for the GD77 type radios , including RD5R
You can calibrate the frequency in the firmware
Re: Reference frequency calibration on RT82
Thank you for your reply. As always, any question is solved by careful reading of the manual =)