Page 1 of 1
point to point digital radio
Posted: Mon Nov 21, 2022 7:48 pm
by PU4BLA
I know that the question runs away from the purpose of the group, if it is not possible to clarify thank you. In the event of having 2 digital radios with opengd77 without access to brandmeister or repeater it is possible to program the codeplug so that the radios communicate in digital alone mode, which configuration to use. I tried several changes color code, ID, frequency, slot - without success
Regards
Re: point to point digital radio
Posted: Mon Nov 21, 2022 8:23 pm
by ok1pt
PU4BLA wrote: ↑Mon Nov 21, 2022 7:48 pm
I know that the question runs away from the purpose of the group, if it is not possible to clarify thank you. In the event of having 2 digital radios with opengd77 without access to brandmeister or repeater it is possible to program the codeplug so that the radios communicate in digital alone mode, which configuration to use. I tried several changes color code, ID, frequency, slot - without success
Regards
Hi!
Of course it's possible. Just set the Rx and Tx freq the same, choose a CC and TG, TS is irrelevant in this mode, and set the same for all the radios. Then they should communicate together.
With regards,
Pavel OK1PT
Re: point to point digital radio
Posted: Mon Nov 21, 2022 10:25 pm
by PU4BLA
thank you very much, I will do that !
Regards
Re: point to point digital radio
Posted: Mon Nov 21, 2022 11:22 pm
by PU4BLA
Sorry for the inconvenience.
I did the programming and even changing the frequency within the band limits on two radios, the message comes when transmitting:
"ERROR OUT OF BAND" can you help me, something is wrong.
Regards
Re: point to point digital radio
Posted: Mon Nov 21, 2022 11:47 pm
by DO3HB
PU4BLA wrote: ↑Mon Nov 21, 2022 11:22 pm
Sorry for the inconvenience.
I did the programming and even changing the frequency within the band limits on two radios, the message comes when transmitting:
"ERROR OUT OF BAND" can you help me, something is wrong.
Regards
Try Options, Radio Options, Band Limits and set it to CPS or OFF
73, DO3HB
Re: point to point digital radio
Posted: Tue Nov 22, 2022 5:31 am
by VK3KYY
DO3HB wrote: ↑Mon Nov 21, 2022 11:47 pm
PU4BLA wrote: ↑Mon Nov 21, 2022 11:22 pm
Sorry for the inconvenience.
I did the programming and even changing the frequency within the band limits on two radios, the message comes when transmitting:
"ERROR OUT OF BAND" can you help me, something is wrong.
Regards
Try Options, Radio Options, Band Limits and set it to CPS or OFF
73, DO3HB
If you set to CPS, you need to make sure the band limit values in the CPS cover the frequencies you want to use.
Re: point to point digital radio
Posted: Fri Nov 25, 2022 4:57 pm
by PU4BLA
I thank you for your support and i congratulate all the team that develops OPENGD77.
Regards