Hotspot mode - Apparently stuck in TX
Re: Hotspot mode - Apparently stuck in TX
I noticed:
When the Radio enters HotSpot mode and it does not transmit, the radio does not lock.
When, at least once (TX) is performed, after some time the radio locks up.
When the Radio enters HotSpot mode and it does not transmit, the radio does not lock.
When, at least once (TX) is performed, after some time the radio locks up.
Re: Hotspot mode - Apparently stuck in TX
installed 12/7/19 updates.
I know that this is lower priority, but will mention it to update this thread.
Still have the intermittent hotspot hang on Pi-Star "Transmit" bug. This appears to only happen if the local hotspot has received an over the air transmission (Parrot on individual RadioID, not group ID) at some point which was forwarded to the VOIP infrastructure (Brandmeister), then the response transmitted by the hotspot locally.
It fails randomly a few minutes later, even if some other call (group ID) voice packets were received from the VOIP infrastructure.
Is there a recommended tracing setup for use on PiStar to observe the USB port?
Marc
I know that this is lower priority, but will mention it to update this thread.
Still have the intermittent hotspot hang on Pi-Star "Transmit" bug. This appears to only happen if the local hotspot has received an over the air transmission (Parrot on individual RadioID, not group ID) at some point which was forwarded to the VOIP infrastructure (Brandmeister), then the response transmitted by the hotspot locally.
It fails randomly a few minutes later, even if some other call (group ID) voice packets were received from the VOIP infrastructure.
Is there a recommended tracing setup for use on PiStar to observe the USB port?
Marc
Last edited by kd2lh on Sat Dec 07, 2019 6:57 pm, edited 2 times in total.
Re: Hotspot mode - Apparently stuck in TX
Hi Roger
I had this happen. Only once did the radio display a message which said "Waiting for Pi-Star" never had it display that message again.
Hope that Helps to tell whats happening.
Cheers Matt.
I had this happen. Only once did the radio display a message which said "Waiting for Pi-Star" never had it display that message again.
Hope that Helps to tell whats happening.
Cheers Matt.
Re: Hotspot mode - Apparently stuck in TX
I've now got my OpenGD77 hotspot running in the debugger and I'll see if I can catch it going wrong.
Re: Hotspot mode - Apparently stuck in TX
Can someone let me know what TG's you use, where the Hotspot hangs on Tx.
Because I have feeling that its certain conditions on certain talkgroups, and network conditions that cause this problem.
My hotspot has been running for an hour, not going much, for an hour, with no lockups, but those TG's were quiet, so I"ve moved it onto 91 and I'll leave it there for a while.
Because I have feeling that its certain conditions on certain talkgroups, and network conditions that cause this problem.
My hotspot has been running for an hour, not going much, for an hour, with no lockups, but those TG's were quiet, so I"ve moved it onto 91 and I'll leave it there for a while.
Re: Hotspot mode - Apparently stuck in TX
Interestingly.
I just changed the power when there was an incoming signal, and it seemed to have the Tx hang thing for about 10 secs, but its now recovered.
I just changed the power when there was an incoming signal, and it seemed to have the Tx hang thing for about 10 secs, but its now recovered.
Re: Hotspot mode - Apparently stuck in TX
No special TGs that I use, just our local 220 (Serbia), 220011 (Belgrade 1) & 220010 (Belgrade 2).
Re: Hotspot mode - Apparently stuck in TX
Still working OK. on TG91.
How long does it take to go wrong.
BTW. What Raspberry Pi are you using. I'm currently using a 3B, connected via Wifi
How long does it take to go wrong.
BTW. What Raspberry Pi are you using. I'm currently using a 3B, connected via Wifi