squelch bug

[OM8AMV]

5W, its a cca 20km. Other repeater has a RX 169,300 and TX 162,275 and this work ok, no beep.

Edit, when i set 4W, no problem. Why is on 5W only ?

[Renco]

I have the same bug on DM-1801.
So what I've found...
If the radio is in silent mode and when I transmit, right after transmitting radio beeps and squelch becomes disabled. Switching radio off and on helps to enable squelch again.
If I set radio in beep mode (and set it to -24 dB to get pseudosilent), squelch is OK.

I've noticed it since not working silent mode bug was fixed in August.

[VK3KYY]

I have the same bug on DM-1801.
So what I've found...
If the radio is in silent mode and when I transmit, right after transmitting radio beeps and squelch becomes disabled. Switching radio off and on helps to enable squelch again.
If I set radio in beep mode (and set it to -24 dB to get pseudosilent), squelch is OK.

I've noticed it since not working silent mode bug was fixed in August.

What is your callsign ?

[VK3KYY]

I have the same bug on DM-1801.
So what I've found...
If the radio is in silent mode and when I transmit, right after transmitting radio beeps and squelch becomes disabled. Switching radio off and on helps to enable squelch again.
If I set radio in beep mode (and set it to -24 dB to get pseudosilent), squelch is OK.

I've noticed it since not working silent mode bug was fixed in August.

Please give full details of your channel setup.

FM. Wide or Narrow
CTCSS or DCS settings
Any other settings on the radio which are not the default settings


Basically, I can't replicate your bug, given the limited information you posted.

FM works fine, Sound set to silent. squelch opens and closes as it should.
However I have not enabled CTCSS or DCS, which you may have enabled.

[OM8AMV]

I have the same bug on DM-1801.
So what I've found...
If the radio is in silent mode and when I transmit, right after transmitting radio beeps and squelch becomes disabled. Switching radio off and on helps to enable squelch again.
If I set radio in beep mode (and set it to -24 dB to get pseudosilent), squelch is OK.

I've noticed it since not working silent mode bug was fixed in August.

Please give full details of your channel setup.

FM. Wide or Narrow
CTCSS or DCS settings
Any other settings on the radio which are not the default settings


Basically, I can't replicate your bug, given the limited information you posted.

FM works fine, Sound set to silent. squelch opens and closes as it should.
However I have not enabled CTCSS or DCS, which you may have enabled.

Here is my channel setup details
RX fq is 169,250Mhz
TX fq is 166,650Mhz
CTCSS tone is 88,5kHz
FM Wide, silent mode

[Renco]

What is your callsign ?

UB1APR

[Renco]

Please give full details of your channel setup.

FM. Wide or Narrow
CTCSS or DCS settings
Any other settings on the radio which are not the default settings


Basically, I can't replicate your bug, given the limited information you posted.

FM works fine, Sound set to silent. squelch opens and closes as it should.
However I have not enabled CTCSS or DCS, which you may have enabled.

Rx and Tx 445.975 MHz.
FM Narrow.
No CTCSS or DCS.
Mic gain +3 dB.
Nothing more I think.

Silent mode - squelch doesn't work.
Beep mode - everything is OK.