OpenGD77

Thanks Ken

Its good to know its not just me thats running these new development releases.

The more the merrier in terms of testing.

Running it on two GD77s here with no issues.

Well, of course you are not alone. There are (I guesstimate) more then few of us that always use latest development versions, but don't write so much any more, cause firmware is quite stable now.

everything is great here. it's the only radio I use.

just awaiting the teasmade interface

VK3KYY wrote: ↑

Mon Jul 06, 2020 11:18 am

Its good to know its not just me thats running these new development releases.

The more the merrier in terms of testing.

Hello Roger

I check every morning if there is a new release. If so, it will be flashed too.
I usually do not confirm the test here, only if there are problems with the version, I write it here.

Believe me, testing it a lot more than you think ...

Great works but reverse is only momentary when pressed both side keys ?

OM8AMV wrote: ↑

Mon Jul 06, 2020 5:26 pm

Great works but reverse is only momentary when pressed both side keys ?

Yes it is. In VFO, you can already exchange RX/TX frequencies (orange menu).

Cheers.
---
Daniel

ok, thanks, but in channel mode is momentary. Its not practical hold 2 keys when i measure a input signal of radio. Its better switch to reverse mode and back to normal mode.

OM8AMV wrote: ↑

Mon Jul 06, 2020 7:43 pm

ok, thanks, but in channel mode is momentary. Its not practical hold 2 keys when i measure a input signal of radio. Its better switch to reverse mode and back to normal mode.

Copy the channel to the VFO, this way you can easily switch the frequencies.

only in VFO mode is possible to switch ?