Page 4 of 69
Re: New ongoing "Development" version has been created
Posted: Mon Jul 06, 2020 11:18 am
by VK3KYY
Thanks Ken
Its good to know its not just me thats running these new development releases.
The more the merrier in terms of testing.
Re: New ongoing "Development" version has been created
Posted: Mon Jul 06, 2020 12:05 pm
by N1KY
Running it on two GD77s here with no issues.
Re: New ongoing "Development" version has been created
Posted: Mon Jul 06, 2020 12:06 pm
by YT5HOK
Well, of course you are not alone.
There are (I guesstimate) more then few of us that always use latest development versions, but don't write so much any more, cause firmware is quite stable now.
Re: New ongoing "Development" version has been created
Posted: Mon Jul 06, 2020 2:43 pm
by m1dyp
everything is great here. it's the only radio I use.
just awaiting the teasmade interface
Re: New ongoing "Development" version has been created
Posted: Mon Jul 06, 2020 4:47 pm
by DO4CZ
VK3KYY wrote: ↑Mon Jul 06, 2020 11:18 am
Its good to know its not just me thats running these new development releases.
The more the merrier in terms of testing.
Hello Roger
I check every morning if there is a new release. If so, it will be flashed too.
I usually do not confirm the test here, only if there are problems with the version, I write it here.
Believe me, testing it a lot more than you think ...
Re: New ongoing "Development" version has been created
Posted: Mon Jul 06, 2020 5:26 pm
by OM8AMV
Great works
but reverse is only momentary when pressed both side keys ?
Re: New ongoing "Development" version has been created
Posted: Mon Jul 06, 2020 5:40 pm
by F1RMB
OM8AMV wrote: ↑Mon Jul 06, 2020 5:26 pm
Great works
but reverse is only momentary when pressed both side keys ?
Yes it is. In VFO, you can already exchange RX/TX frequencies (orange menu).
Cheers.
---
Daniel
Re: New ongoing "Development" version has been created
Posted: Mon Jul 06, 2020 7:43 pm
by OM8AMV
ok, thanks, but in channel mode is momentary. Its not practical hold 2 keys when i measure a input signal of radio. Its better switch to reverse mode and back to normal mode.
Re: New ongoing "Development" version has been created
Posted: Tue Jul 07, 2020 3:29 am
by F1RMB
OM8AMV wrote: ↑Mon Jul 06, 2020 7:43 pm
ok, thanks, but in channel mode is momentary. Its not practical hold 2 keys when i measure a input signal of radio. Its better switch to reverse mode and back to normal mode.
Copy the channel to the VFO, this way you can easily switch the frequencies.
Re: New ongoing "Development" version has been created
Posted: Tue Jul 07, 2020 12:31 pm
by OM8AMV
only in VFO mode is possible to switch ?