Re: Release 30th April
Posted: Thu Apr 30, 2020 4:12 pm
Hello Roger,
I'll try it on my GD77 and RD5R
Ciao
Eugenio
I'll try it on my GD77 and RD5R
Ciao
Eugenio
Amateur radio firmware for the GD-77, GD-77S, DM-1801, DM-1801A, RD-5R, MD-9600/RT-90, MD-UV380/RT-3S, DM-1701/RT-84 and MD2017/RT-82 radios
https://www.opengd77.com/
If you have access to frequency counter, you can check if it's properly aligned.do2sta wrote: ↑Fri May 01, 2020 6:23 amUnfortunately my RD5R does not work with the new firmware and my MMDVM hotspot. I would probably have to make an RX / TX correction at the MMDVM hotspot. Then my other radio devices with the hotspot no longer work. I hope there is still a solution. 73 Stefan, DO2STA
New firmware .It works fine with my MMDVM hotspot .do2sta wrote: ↑Fri May 01, 2020 6:23 amUnfortunately my RD5R does not work with the new firmware and my MMDVM hotspot. I would probably have to make an RX / TX correction at the MMDVM hotspot. Then my other radio devices with the hotspot no longer work. I hope there is still a solution. 73 Stefan, DO2STA
Unfortunately, I have the same problem and that's why I downloaded the factory software again and my RD-5R connects seamlessly to my two single- and dual-slot hotspots. After uploading OpenRD-5R software I can no longer connect to either hotspot or the other. Only after reducing the frequency -700Hz in TX radio was restored. I can't change anything in the hotspot (Offset), because the other three radios will have the same problem as the RD-5R.do2sta wrote: ↑Fri May 01, 2020 6:23 amUnfortunately my RD5R does not work with the new firmware and my MMDVM hotspot. I would probably have to make an RX / TX correction at the MMDVM hotspot. Then my other radio devices with the hotspot no longer work. I hope there is still a solution. 73 Stefan, DO2STA
Maybe this help:4O6DTM wrote: ↑Fri May 01, 2020 10:20 pmHi,
does anyone else have the problem on FM, especially on repeaters, when the other party is over-modulated (to close to microphone or too much mic gain), the RX on GD77 starts to break (stutter) ? I noticed this on two latest final releases.
Otherwise working great, thank you!
73, de 4O6DTM