OpenGD77

i program my dm1801 with the bf1801 sopware and make right and when i program the cps on the radio the zone content is not display right on the software any idea why..???

Hello!

Same problem here.

I have 2 zones in my codeplug, but only 1 zone appear ok the radio menu.

No solution yet now.

73, Clovis, PY3OG

Probably your codeplug data is corrupt.

You should make a new codeplug

I tried various codeplugs with the same results.

No idea.

73, Clovis PY3OG

Hi,

py3og wrote: ↑

Fri Oct 01, 2021 11:59 pm

I tried various codeplugs with the same results.

No idea.

73, Clovis PY3OG

Can you post the codeplug (zip it before posting) ?


Cheers.
---
Daniel

Hello Daniel!

Thanks for help.
My codeplug is a very simple one.
Please, check it.

73, Clovis- PY3OG

Hi,

py3og wrote: ↑

Sat Oct 02, 2021 10:37 am

Hello Daniel!

Thanks for help.
My codeplug is a very simple one.
Please, check it.

73, Clovis- PY3OG

Question: are you using the OpenGD77 firmware on your DM-1801 ?
In this case, you NEED to use the OpenGD77 CPS software, available here


Cheers.
---
Daniel

Thanks Daniel!

No. I want to return to original firmware. So, I am not using Open GD77 codeplug.


73, Clovis- PY3OG

Hi Clovis,

Ah, then we can't help you that much, as the point of this forum is the OpenGD77 firmware and CPS. If you're back to the manufacturer FW and CPS, just pick and install the latest available, and start a codeplug from scratch.


Cheers.
---
Daniel

Hi Daniel!

No problem. I only replay original post about DM-1801, because I experienced the same problem, without solution.
I am using OpenGD at this moment.
Sorry for off-topic.

73, CLOVIS, PY3OG