How to adjust output power
How to adjust output power
Looking at the guide, you use {D} < or > to adjust power on the fly. This is not working on my MD 9600. How do you adjust power on fly?
Thanks for responses. Loving this software over the TYT.
Thanks for responses. Loving this software over the TYT.
Re: How to adjust output power
P1 + Up/Down arrow on radio
Longpress D and then B/C buttons on mic.
Re: How to adjust output power
Thank you for the response. That is what I'm doing, long D and using the B and C buttons and that is not working. Is there a particular setting in the CPS to use the function? I've tried Master, 40W and -W+ settings. Not working those setting. I would expect to see the display change wattage settings as well as the watt meter. Not see a change at all.
Re: How to adjust output power
Problem solved. Operator error. Long press D for 2 seconds and then only use B or C, otherwise B and C control squelch. I was holding D down the whole time. My bad. Thanks for the response.
Re: How to adjust output power
This is a limitation of the microphone hardware. It is not possible to detect two keys pressed at the same time. Hence we had to use 'long press D and release' to toggle the shift function.
Colin G4EML
Colin G4EML
Re: How to adjust output power
Hehe, I was thinking of being more pedagogic in my answer by trying to explain that you should wait for the special beep that signal that
we are in latch mode after long press D