No output on VHF
No output on VHF
Hello, I just undated my RT90 V2.1 to the latest version but have power output on 2M 145 MHz analogue. If I turn the power on the 40 watt I do get 0.4 watts out of it. It's like the PA for VHF has blown but it was ok before. Any ideas please?
Thanks Lee.
Thanks Lee.
Re: No output on VHF
The RT90/MD9600 only has one PA, so if it is working on UHF then it is not damaged.
Are you sure that you loaded the correct firmware version for your radio? Mismatched versions will not transmit.
Colin G4EML.
Are you sure that you loaded the correct firmware version for your radio? Mismatched versions will not transmit.
Colin G4EML.
Re: No output on VHF
Thank for the replay, on the board is marked MD9600-UV-V2.1-170608 so I used firmware ver2. 70CM UHF works fine. Tried version 3 but this made it transmit of frequency.
Lee.
Lee.
Re: No output on VHF
Buen día, quizá sirva contar mi experiencia. Me sucedió lo mismo, salida normal en UHF y no salida en VHF. Concurrí a los servicios de LU2DR quien pudo determinar que un diodo PIN de la plaqueta madre estaba fuera de servicio, se reemplazó dicho componente y el TYT 9600 volvió a funcionar normalmente.
Re: No output on VHF
Don't suppose you know where these diodes are?LU2BAM wrote: ↑Thu Oct 05, 2023 1:48 pmBuen día, quizá sirva contar mi experiencia. Me sucedió lo mismo, salida normal en UHF y no salida en VHF. Concurrí a los servicios de LU2DR quien pudo determinar que un diodo PIN de la plaqueta madre estaba fuera de servicio, se reemplazó dicho componente y el TYT 9600 volvió a funcionar normalmente.
Re: No output on VHF
Buenas tardes Lee, te envié fotografías a tu correo electrónico del diodo PIN en cuestión.
Re: No output on VHF
diodo PIN dañado