Hello everyone, I have read everything I read here about the GD77 software for retevis rt3 s.
My question is, what do you want to hear for time slot 1 or 2?
Can anyone tell me anything about this? I've already put everything back and forth, even when sending, it sends to both time slots
I currently haven't found the beta 2023 05 09 on it with the release candidate 2023 03 10 or which one should I play that works
time slot 1 or 2?
Re: time slot 1 or 2?
I don't fully understand your question.
If you are asking about simplex operation then OpenGD77 only supports basic DMO mode. In this mode the signal contains no timeslot information, so the setting is not important. DMO mode only supports one conversation per frequency.
Timeslot setting is only important when using a duplex repeater in RMO mode.
Colin G4EML
If you are asking about simplex operation then OpenGD77 only supports basic DMO mode. In this mode the signal contains no timeslot information, so the setting is not important. DMO mode only supports one conversation per frequency.
Timeslot setting is only important when using a duplex repeater in RMO mode.
Colin G4EML
Re: time slot 1 or 2?
in duplex I mean you hear time slot 1 and 2 every time I would like to turn it off so that you only hear 1 or 2 on the repeater and where you change it and I don't understand dmo and tmo that's a different procedure, no DMR like that in tetra here there is simplex and duplex and you mean gd 77 can only do both together in simplex and not watered and if I need simplex but only timeslot 1 and not both together that is not possible or can you make it wrong that you watered the when receiving 1 can use time slots to send and hear that with 2 but not both together
Re: time slot 1 or 2?
In Duplex you will only hear the TS displayed on the screen (1 or 2) Unless you have Disabled the TimeSlot filter in the Quick Menu.
If you disable TS filter then you will hear both TS, but this is not the default
Are you definitely listening to a Duplex repeater or Duplex hotspot ? Are you sure you have not setup a static or dynamic route so that the same trafffic is on TS 1 and TS 2 ?
If you disable TS filter then you will hear both TS, but this is not the default
Are you definitely listening to a Duplex repeater or Duplex hotspot ? Are you sure you have not setup a static or dynamic route so that the same trafffic is on TS 1 and TS 2 ?