UA0LMC wrote: ↑Mon Dec 19, 2022 7:12 pm
Now I'm working on the mod to at least keep the almanac until the radio is on. Will write a post about it if/when I finish.
There are some PCB design flaws which make it a little harder to do than I thought.
DISCLAIMER: this mod requires some fine soldering.
I performed this mod and tested it on my radio - but your radio is only yours. Do it at your own risk.
What it does:
It keeps GPSr Vbackup powered all the time the radio is on - thus retaining the almanac regardless of GPS on or off state. This mod significantly speeds-up the re-acquisition when re-enabling GPS.
Also it allows some kind of GPSr Eco-mode as hot-start is now supported - but it's up to developers whether it will be implemented in software or not.
What it does not:
It does not speed-up the first acquisition. Also it does not improve overall GPS reception.
It won't retain the almanac when the radio is powered off. Using the onboard RTC battery for GPSr backup is impractical as GPSr will drain it in 3-4 days. Adding a separate stand-by power supply was considered too difficult for most of the users to implement it.
OK, so what do I need to do?
0. Open the radio, locate the GPSr module on the front panel PCB.
1. Remove the resistor and cut two traces along the red lines.
2. Connect two yellow dots with a thin wire jumper (preferably PTFE-insulated).
3. Connect two blue dots the same way.
![IMG_20221221_141223_1.jpg](./download/file.php?id=1536&sid=889570e742eac498b63cd21ad7570201)
- IMG_20221221_141223_1.jpg (71.24 KiB) Viewed 12451 times
In the end you should get something like this:
![IMG_20230101_184709_1.jpg](./download/file.php?id=1537&sid=889570e742eac498b63cd21ad7570201)
- IMG_20230101_184709_1.jpg (74.42 KiB) Viewed 12451 times