I've just downloaded the firmware posted on 20th Dec.
How do I set in the VFO, a 2 meter (145Mhz) TX and 70cm (436Mhz) RX?
- [EDIT] I found the setting for this one. Menu > Channel Details > Rx & Tx
Is the step hard coded, or is there an option in the menu to change this?
- [EDIT] I found the setting for this one. Menu > Channel Details > Step
Is there an ability to set the Bandwiths separatly for each RX & TX.
2m should be 12.5Khz and 70cm should be 25Khz
[EDIT]
I've saved my Sat channels and set a Zone.
To use a freq, I copy to VFO, using quick menu.
Would it be possible to set Low freq to the RX freq and add 20Khz?