Page 1 of 1
MD9600 Hotspot Mode using DVSwitch (MMDVM_Bridge) in debian 10 ?
Posted: Tue Mar 12, 2024 2:12 am
by xe2cs
Is it possible to setup a MD9600 Hotspot Mode using DVSwitch (MMDVM_Bridge) in debian 10 ?
I already install DVSwitch server and running MMDVM_bridge, and set up using the /dev/ttyACM0 , is the port detected in debian
Thanks in advance
Re: MD9600 Hotspot Mode using DVSwitch (MMDVM_Bridge) in debian 10 ?
Posted: Tue Mar 12, 2024 8:24 am
by SA0BUX
xe2cs wrote: ↑Tue Mar 12, 2024 2:12 am
Is it possible to setup a MD9600 Hotspot Mode using DVSwitch (MMDVM_Bridge) in debian 10 ?
I already install DVSwitch server and running MMDVM_bridge, and set up using the /dev/ttyACM0 , is the port detected in debian
Thanks in advance
I use MMDVMHOST on my debian bookworm together with MD-9600 in MMDVM hotspot mode , works fine.
Using "UARTPort=/dev/ttyACM0"
Re: MD9600 Hotspot Mode using DVSwitch (MMDVM_Bridge) in debian 10 ?
Posted: Wed Mar 13, 2024 3:50 am
by R9OBQ
As far as I recall my work with this program, MMDVM_bridge basically does not interact with the MMDVM modem. It is a software stub for other things.
Re: MD9600 Hotspot Mode using DVSwitch (MMDVM_Bridge) in debian 10 ?
Posted: Wed Mar 13, 2024 6:23 am
by VK3KYY
Hotspot needs to be enabled in the Options in the firmware, otherwise the Com port will communicate with the MMDVMHost serial protocol
Reading the MMDVM Bridge docs e.g.
https://www.qsl.net/kb9mwr/projects/dv/ ... Bridge.pdf
It says "All Ports are UDP"
i.e this software is a network connectivity application
You need to run MMDVMHost to commicate with the MD9600 acting as a MMDVM modem.