Hi Piotr,
SQ7PTE wrote: ↑Sun Dec 20, 2020 10:04 am
Hello Daniel.
So far, HotSpot worked with the full power of 5 ++ (of course in the version from 03/05/2020) because, as I have already mentioned in another topic, after this version, each new version caused the error I was describing. Now, after uploading the latest Firmware, the text 1W appeared on the screen - I can't change it, that's why I asked.
As it was stated long ago, if your MMDVMHost config has RFLevel set to 100, the current power set on the GD will be used, otherwise, refer to the power/value table.
About the error you're mentioning, if it's about the USB reset because of the power fed back to the RPi USB port, it has also been stated that we can't fix your installation by software, at it's purely a RF problem, induced by cabling, etc.