What parameters are needed when configuring the hotspot?
I see that the power cannot be 100% as it then ignores it and works with the power marked in the GD77.
Offset tx and rx ... does not seem necessary, either.
The DMR modulation level has no effect, I suppose it is a parameter that is managed by the internal DMR chip.
Is there any other important parameter?
Thanks!
73 from Catalonia.
pistar parameters
Re: pistar parameters
No special parameters are needed.
Offset is not required.
If you use PiStar 4, you can set the Display type to cast In the Expert->MMDVMHost settings, and PiStar will send the callsign etc to the radio
Offset is not required.
If you use PiStar 4, you can set the Display type to cast In the Expert->MMDVMHost settings, and PiStar will send the callsign etc to the radio
Re: pistar parameters
cast is not the same as DMR EmbeddedLCOnly in 3 versions?
Re: pistar parameters
Cast is a display type like OLED or Nextion etc, its not related how MMDVMhost handles embedded / TA data.